Alcatel-Lucent 7210 SAS-D Configuration Manual page 442

System Commands
sync-if-timing
Syntax sync-if-timing
Context show>system
Description This command displays synchronous interface timing information.
Output System Timing Output — The following table describes sync-if-timing output fields.
Page 442
Label
System Status CPM A
Reference Input Mode
Reference Order
Reference Input 1
Admin Status
Qualified for Use
Selected for Use
Source Port
Reference Input 2
Not Selected Due to
Quality Level Selec-
tion
System Quality Level
Rx Quality Level
7210 SAS D, E, K OS Basic System Configuration Guide
Indicates the system status of CPM A.
Indicates the reference input mode.
Indicates the reference order.
Displays information about reference input 1
down — Indicates the ref1 or ref2 configuration is administratively
shutdown.
up — Indicates the ref1 or ref2 configuration is administratively
enabled.
diag — Indicates the reference has been forced using the force-refer-
ence command.
Indicates if the reference input 1 (or input 2) is qualified for use.
Indicates if reference input 1(or input 2) is selected for use.
Displays the source port information.
Displays information about reference input 2.
Indicates the reason if reference input 2 is not selected.
Note: SSM is supported only on 7210 SAS-D devices.
Indicates whether the ql-selection command has been enabled or dis-
abled. If this command is enabled, then the reference is selected first
using the QL value, then by the priority reference order. If this com-
mand is not enabled, then the reference is selected by the priority refer-
ence order.
Indicates the quality level being generated by the system clock.
Indicates the QL value received on the interface.
• inv - SSM received on the interface indicates an invalid code for
the interface type.
• unknown - No QL value was received on the interface.
Description