Alcatel-Lucent 7210 SAS-D Configuration Manual page 128

Configuration and Image Loading
Note 1: The BOF password can be changed from default value to any other user defined value
only at the Timos level.
Note 2: It is highly recommended that user does not rename cf1:\boot.tim and cf1:\both.tim, if the
system needs to retain them during the password recovery procedure. Additionally, it is highly
recommended that the user takes a backup of all the image files, configuration files and other data.
The following logs show the system prompts displayed on the console when user forgets the
password and chooses to reset the password to factory default setting. Also, shown are the BOF
contents after and before the reset. Note that the BOF parameters are set to default after password
reset.
TiMOS BOOT LOADER
CPLD Version: 2.1
Time from clock is FRI AUG 19 09:22:46 2011 UTC
USB:
scanning bus for devices...
1 USB Device(s) found
Number of blocks in device 0 is 0
Number of bytes per block in device 0 is 0
Switching serial output to sync mode...
Looking for cf1:/bof.cfg ... OK, reading
Contents of Boot Options File on cf1:
primary-image
primary-config
#eth-mgmt Port Settings:
no
eth-mgmt-address
eth-mgmt-route
eth-mgmt-autoneg
eth-mgmt-duplex
eth-mgmt-speed
#uplinkA Port Settings:
uplinkA-port
uplinkA-address
uplinkA-vlan
#uplinkB Port Settings:
uplinkB-port
uplinkB-address
uplinkB-vlan
#System Settings:
wait
persist
console-speed
uplink-mode
acl-mode
use-expansion-card-type
no
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Page 128
USB EHCI 1.00
ftp://*:*@135.250.27.40/xxx/xx/xxx/xx/xxx/both.tim
cf1:\sasm.cfg
eth-mgmt-disabled
10.135.20.115/24 active
0.0.0.0/0 next-hop 10.135.20.1
full
100
1/1/1
0
0
1/1/2
0
0
3
off
115200
network
IPv6-None
console-disabled
7210 SAS D, E, K OS Basic System Configuration Guide
done
m4-ds1-ces