Alcatel-Lucent 7210 SAS-D Configuration Manual page 244

Common Configuration Tasks
Server
The Server command is used when the node should operate in client mode with the NTP server
specified in the address field. Use the no form of this command to remove the server with the
specified address from the configuration.
Up to five NTP servers can be configured.
CLI Syntax: config>system>time>ntp
Example
The following example shows NTP enabled with the
A:7210SAS>config>system>time>ntp# info
----------------------------------------------
----------------------------------------------
A:7210SAS>config>system>time>ntp#
Page 244
server {ip-address |ptp}[key-id key-id] [version ver-
sion] [prefer]
:
config>system>time>ntp#
config>system>time>ntp# server 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown
ntp-server
server ptp prefer
broadcast interface "a1"
no shutdown
7210 SAS D, E, K OS Basic System Configuration Guide
command configured.
server