Figure 3-12: End Process Wizard Page - AudioCodes MediaPack MP-11x Series Installation Manual

7. You can now choose to either:
•
Click Reset; the device resets, utilizing the new cmp and ini file you loaded up to
now as well as utilizing the other auxiliary files.
•
Click Back; the 'Load a cmp file' page is opened again.
•
Click Next; the next page opens for loading the next consecutive auxiliary file
listed in the Wizard.
8. Follow the same procedure as for loading the ini file (Step 6) to load the auxiliary files.
9. In the 'FINISH' page (refer to the figure below), the Next button is disabled. Complete
the upgrade process by clicking Reset or Cancel.
•
Click Reset, the device 'burns' the newly loaded files to flash memory and then
resets the device. After the device resets, the 'End Process' screen appears
displaying the burned configuration files (refer to the figure below).
•
Click Cancel, the device resets, utilizing the files previously stored in flash
memory. (Note that these are NOT the files you loaded in the previous wizard
steps).
10. Click End Process, and then in the 'Enter Network Password' dialog box, enter your
login user name and password (described in Accessing the Web Interface) and click
OK; a message box appears informing you of the new CMP file.
11. Click OK; the Web interface now becomes active, reflecting the upgraded device.
Installation Manual

Figure 3-12: End Process Wizard Page

46
MediaPack Series
Document #: LTRT-59809