Figure 3-11: End Process Wizard Page - AudioCodes MediaPack MP-124 Installation Manual

Installation Manual
Note:
4. Click the
file is loaded to the device and you're notified as to a successful loading.
5. Click one of the following buttons:
•
configuration and auxiliary files.
•
Note that as you progress by clicking
applicable Wizard page is highlighted in the file list on the left.
6. In the 'Load an
•
Click
loaded to the device and you're notified as to a successful loading.
•
Use the
ensuring that the 'Use existing configuration' check box is marked (default).
•
Return the device's configuration settings to factory defaults, by not selecting an
ini
7. You can now choose to either:
•
Click Reset; the device resets, utilizing the new cmp and ini
now as well as utilizing the other auxiliary files.
•
Click
•
Click
listed in the Wizard.
8. For loading the auxiliary files, follow the same procedure as for loading the
6).
9. In the 'FINISH' page, complete the upgrade process by clicking
'burns' the newly loaded files to flash memory and then resets the device. After the
device resets, the 'End Process' screen appears displaying the burned configuration
files (refer to the figure below).
Version 6.0
At this stage, you can quit the Software Update Wizard, by clicking Cancel
, without requiring a device reset. However, once you start uploading a
cmp file, the process must be completed with a device reset.
Browse button, navigate to the cmp file, and then click Send File; the cmp
Reset; the device resets with the newly loaded cmp,
Next; the 'Load an ini
ini File' page, you can now choose to either:
Browse, navigate to the ini file, and then click Send File; the ini
ini file currently used by the device, by not selecting an ini
file and by clearing the 'Use existing configuration' check box.
Back; the 'Load a cmp
Next ; the next page opens for loading the next consecutive auxiliary file

Figure 3-11: End Process Wizard Page

File' wizard page opens.
Next , the relevant file name corresponding to the
file' page is opened again.
51
3. Configuring the Device
utilizing the existing
file is
file and by
file you loaded up to
ini file (Step
Reset; the device
March 2010