Table of Contents
Advertisement
Cisco RFGW-10 Components
Supervisor Engine Components
The following connectors, LEDs, and buttons are located on the front panel of the supervisor engine:
•
•
•
•
•
•
•
•
•
Supervisor Engine LEDs
Table 1-7
Table 1-7
Supervisor Engine LEDs
LED
STATUS
UTILIZATION
LINK
Active
Ethernet Management Port
The supervisor engine has a 10/100 BASE-T Ethernet management port. The Supervisor engine uses an
RJ-45 connector on the front panel with a link status LED.
Cisco RF Gateway 10 Hardware Installation Guide
1-16
The STATUS LED, which indicates the operating state of the module
Two Gigabit uplink ports
Four SFP Gigabit uplinks ports
Eight utilization indicator LEDs, which provide an approximation of the current traffic across the
backplane
A console port (RJ-45)
An Ethernet management port (RJ-45)
A link status LED, which provides status for the management port
The Reset button (recessed), which allows you to reset the system
The Compact Flash port and eject button
describes the meaning of the Supervisor Engine LEDs.
Status
Green
Red
Orange
Off
Green 1-100%
Green
Orange
Flashing orange
Off
Green
Off
Meaning
All diagnostic tests passed.
A test failed.
System boot or diagnostic test is in progress.
Supervisor is disabled.
If the switch is operational, this display indicates the current
traffic load over the backplane (as an approximate
percentage). Each LED lit green indicates approximately
12.5% of the load.
The link is operational.
The link is disabled by user.
The power-on self-test indicates a faulty port.
No signal is detected or there is a link configuration failure.
The port is active.
The port is not active.
Chapter 1
Overview
OL-16264-04
Advertisement
Table of Contents
