Cisco RFGW-10 Hardware Installation Manual page 44

Supported External AC-Input Power Shelf
Each AC-input power supply module is automatically powered on when it is plugged into the wall
socket. (See
Figure 1-17
Front view
1
1
2
All cable connections for AC-input power, DC-output power, and status signals are made from the rear
of the power shelf. Each AC power supply module has an individual AC facility cord attachment. All
four AC-input cords must be attached to the facility for all four AC power modules to function. The
DC-interconnect cables provide DC-output power to the DC PEM modules on the Cisco RFGW-10. (See
Figure
Note
The AC-input and DC-output power cables are supplied along with the Lineage kit. It is recommended
that you use these cables for cabling the shelf to the Cisco RFGW-10.
Cisco RF Gateway 10 Hardware Installation Guide
1-30
Figure 1-17).
Lineage AC-DC Power Shelf - Front and Rear View
Rear view
2
DC power source terminal blocks
AC-input power connectors
1-18).
3 4
2
3
J2 connector
4
J1 connector
Chapter 1 Overview
1
OL-16264-04