Table of Contents
Advertisement
Chapter 3
Cisco RFGW-10 UEQAM Installation
Tip
In the next step, insert the top screw diagonally from the bottom screw that you just attached. This helps
to keep the chassis in place.
b.
Insert a top screw into each side rack-mount bracket and tighten the screw to the rack rail.
c.
Insert a minimum of four screws per bracket on both sides of the chassis.
Figure 3-12
Step 7
Ensure that all the screws on each side of the rack-mount brackets are tightened to the equipment rack
before the chassis installation bracket is removed from the rack.
OL-16264-04
Installing the Cisco RFGW-10 in a Two-Post Equipment Rack
Installing the Cisco RFGW-10 UEQAM in a Rack
Cisco RF Gateway 10 Hardware Installation Guide
3-17
Advertisement
Table of Contents
