Table of Contents
Advertisement
Chapter 5
Installing and Removing FRUs
Note
The TCC card slides into the chassis guides on the sheet metal carrier edge.
Step 7
Pivot the two module ejector levers out and away from the faceplate (see
Figure 5-11
Step 8
Carefully slide the TCC card into the slot until the notches on both the ejector levers engage the chassis
TCC slot's top and bottom.
Step 9
Using the thumb and the forefinger of each hand, simultaneously pivot in both the ejector levers to fully
seat the TCC card in the backplane connector.
Caution
Always use the ejector levers when installing or removing a TCC card. A TCC card that is partially
seated in the backplane will not function correctly.
Step 10
Use a screwdriver to tighten the captive installation screws on each end of the TCC card faceplate.
Note
Tighten the captive screws to 6-8 in-lbs.
OL-16264-04
Pivoting the Two Ejector Levers
Installation and Removal of the TCC Cards
Figure
Cisco RF Gateway 10 Hardware Installation Guide
5-11).
5-21
Advertisement
Table of Contents
