Table of Contents
Advertisement
Chapter 6
Cabling the Cisco RFGW-10 UEQAM
Figure 6-18
Note
Before removing the dust plugs and making any optical connections, observe the following guidelines:
•
Always keep the protective dust plugs on the unplugged fiber-optic cable connectors and the
transceiver optical bores until you are ready to make a connection.
•
Always inspect and clean the SC connector end-faces just before making any connections.
•
Always grasp the SC connector housing to plug or unplug a fiber-optic cable.
Step 5
Remove the dust plugs from the network interface cable SC connectors. Save the dust plugs for future
use.
Step 6
Inspect and clean the SC connector's fiber-optic end-faces.
Tip
For complete information on inspecting and cleaning fiber-optic connections, refer to
Cleaning Procedures for Fiber-Optic
Step 7
Remove the dust plugs from the 10-Gigabit Ethernet X2 transceiver optical bores.
Step 8
Immediately attach the network interface cable SC connectors to the 10-Gigabit Ethernet X2 transceiver.
OL-16264-04
Installing the 10-Gigabit Ethernet X2 Transceiver
10-Gigabit Ethernet X2 transceivers are keyed to prevent incorrect insertion.
Port cover
1
L I N
K
A C
2
T I
V E
L I N
K
A C
T I
V E
Connections.
Cisco RF Gateway 10 Hardware Installation Guide
Cabling the Supervisor Engine
Inspection and
6-23
Advertisement
Table of Contents
