Cisco RFGW-10 Hardware Installation Manual page 136

Installation and Removal of the SFP Modules
Figure 5-21
To remove an actuator/button SFP module from a switching module port, perform the following steps:
Step 1
Gently press the actuator/button on the front of the SFP module until it clicks and the latch mechanism
activates, releasing the SFP module from the port (see
Step 2
Grasp the actuator/button between your thumb and index finger and carefully pull the SFP module from
the port.
Cisco RF Gateway 10 Hardware Installation Guide
5-30
Inserting an Actuator/Button SFP Module
W S - 4
4 4 8 - G
B - L X
1
3
2
4
2
4
5
7
6
8
6
8
Figure 5-22).
Chapter 5 Installing and Removing FRUs
OL-16264-04