Preparing Your Site For Installation; Safety Recommendations - Cisco RFGW-10 Hardware Installation Manual

Preparing Your Site for Installation

Before you install the Cisco RFGW-10 UEQAM, consider:
•
The power and cabling requirements that must be in place at your installation site
•
The equipment required to install the router
•
The environmental conditions your installation site must meet to maintain normal operation
This chapter contains important safety information you should know before working with the Cisco
RFGW-10 UEQAM and guides you through the process of preparing your site for router installation.
Note
Do not unpack the system until you are ready to install it. Keep the chassis in the shipping container to
prevent accidental damage until you determine an installation site. Use the appropriate unpacking
documentation included with the system.
Read the installation instructions before connecting the system to the power source. Statement
Warning
1004
Only trained and qualified personnel should be allowed to install, replace, or service
Warning
this equipment. Statement 1030
Ultimate disposal of this product should be handled according to all national laws and
Warning
regulations. Statement 1040
Class 1 laser product. Statement 1008
Warning
This chapter contains the following sections:
•
Safety Recommendations, page 2-2
•
Compliance Requirements, page 2-3
•
Cautions and Regulatory Compliance Statements for NEBS, page 2-3
•
Standard Warning Statements, page 2-4
•
Site Planning, page 2-7
OL-16264-04
C H A P T E R
Cisco RF Gateway 10 Hardware Installation Guide
2
2-1