Cisco RFGW-10 Hardware Installation Manual page 51

Chapter 2 Preparing Your Site for Installation
Ultimate disposal of this product should be handled according to all national laws and
Warning
regulations. Statement 1040
Warning Installation of the equipment must comply with local and national electrical codes. Statement
1074
Warning To comply with FCC Part 15 regulations- special UTP cables with ferrite have to be used to
connect Ethernet and Console ports on Supervisor card.
Power cable and AC adapter - When installing the product, please use the provided or designated
Warning
connection cables/power cables/AC adaptors. Using any other cables or adapters could cause a
malfunction or a fire. Electrical Appliance and Material Safety Law prohibits the use of certified
cables (that have the 'UL' shown on the code) for any other electrical devices than products
designated by Cisco. The use of cables that are certified by Electrical Appliance and Material
Safety Law (that have 'PSE' shown on the code) is not limited to Cisco-designated products.
Statement 371
Only trained and qualified personnel should be allowed to install or replace this equipment
Warning
Statement 1030
This product relies on the building's installation for short-circuit (overcurrent) protection.
Warning
Ensure that the protective device is rated not greater than: DC PEM for RFGW-10 : 60A U.S.
maximum. Statement 1005
Warning This product requires short-circuit (overcurrent) protection to be provided as part of the
building installation. Install only in accordance with national and local wiring regulations.
Statement 1045
Warning This unit may have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Hazardous voltage or energy may be present on the DC power terminals. Always replace cover
Warning
when terminals are not in service. Be sure un-insulated conductors are not accessible when cover
is in place. Statement 1075
Use copper conductors only. Statement 1025
Warning
OL-16264-04
Cisco RF Gateway 10 Hardware Installation Guide
Standard Warning Statements
2-5