Table of Contents
Advertisement
Installing the Cisco RFGW-10 UEQAM in a Rack
Figure 3-9
Step 7
Hold the chassis in position against the mounting rails and follow these steps:
a.
Insert a bottom screw into the rack-mount ear on each side and use a hand-held screwdriver to
tighten the screw to the rack rail.
Tip
In the next step, insert the top screw diagonally from the bottom screw that you just attached. This helps
in keeping the chassis in place.
b.
Insert a top screw into each side rack-mount bracket and tighten the screw to the rack rail.
c.
Insert a minimum of four screws per bracket on both sides of the chassis.
Cisco RF Gateway 10 Hardware Installation Guide
3-14
Positioning the Chassis on the Rack
Chapter 3
Cisco RFGW-10 UEQAM Installation
Fan tray
handle
OL-16264-04
Advertisement
Table of Contents
