Attaching The Cable-Management Bracket - Cisco RFGW-10 Hardware Installation Manual

Attaching the Cable-Management Bracket

Step 5
Locate the chassis ground connector on the rear lower left side of your chassis.
Step 6
Insert the two screws through the holes in the grounding lug M5 screws (provided in the accessory kit)
until the grounding lug is held firmly to the chassis.
Step 7
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure
an adequate chassis ground.
Attaching the Cable-Management Bracket
The rear RF cable-management brackets mount to the rear left side of the chassis to provide
cable-management to coaxial cables exiting the RF switch modules. This bracket allows reference
configuration that allows installation and removal of cables and modules in the rear of the chassis.
The RF cable-management bracket for the Cisco RFGW-10 UEQAM contains 12 independent
cable-management "U" type features with three captive screws for attaching to the chassis, and provides
cable dressing of each RF switch card module slot. (See
Figure 3-16
Follow these steps to attach the cable-management brackets to the rear sides of the Cisco RFGW-10
chassis in the rack:
Step 1
Align the cable-management bracket captive screws to the rear left side panel tapped holes of the Cisco
RFGW-10 chassis.
Step 2
If accessible, use a Phillips screwdriver to secure the captive screws to the chassis. If the captive screws
are not accessible, hand tighten the captive screws.
Cisco RF Gateway 10 Hardware Installation Guide
3-20
Cable-Management Bracket
Chapter 3 Cisco RFGW-10 UEQAM Installation
Figure 3-16.)
OL-16264-04