Connecting A Single Power Shelf; Required Tools And Equipment - Cisco RFGW-10 Hardware Installation Manual

Connecting the Lineage Power Shelf to the Cisco RFGW-10
1
2
Step 4
Place the safety covers on the DC terminal blocks.
Step 5
Proceed to connecting the Lineage power shelf to the Cisco RFGW-10 chassis.
•
•
Step 6
Connect the de-energized AC power cables to the power shelf.
Step 7
Connect the AC power cables to the facility wall socket to energize the power shelf.
Caution
Exercise caution while connecting the AC power cables to the an energized wall socket because the
power shelf will start supplying power to the Cisco RFGW-10.

Connecting a Single Power Shelf

Required Tools and Equipment

•
•
•
•
•
Note
It is recommend that you use the Y-Shaped DC power cables provided in the Lineage accessory kit. If
you are using a 4 AWG cable, use a high-flex high strand count power cable for optimal routing of the
cables under the front cover of the Cisco RFGW-10 chassis. The 2 AWG wire is not supported on the
RFGW-10-PWR-DC1= DC PEM module.
Cisco RF Gateway 10 Hardware Installation Guide
3-30
Power shelf connector
DC PEM module connector
Single Lineage power shelf configuration—If you are using this configuration, see
Single Power Shelf" section on page
Dual Lineage power shelves configuration—If you are using this configuration, see
Dual Power Shelves" section on page
DC PEM module (RFGW-10-PWR-DC1=)
One Lineage AC-DC power shelf
Four Y power cables (Amphenol), provided in the Lineage accessory kit
Flat-head screwdriver
10 mm hex socket driver
Chapter 3
3
DC PEM module connector
—
3-30.
3-32.
Cisco RFGW-10 UEQAM Installation
"Connecting a
"Connecting
OL-16264-04