Cabling the Line Cards
Figure 6-26
Step 4
Place the removed SFP transceiver in an antistatic bag or other protective environment.
Connecting to the ASI Monitor Port (Optional)
You can route the input of a single QAM channel to the Asynchronous Serial Interface (ASI) port to
monitor the channel on appropriate test equipment. A cable with a male BNC connector (not supplied)
is required to connect to the port labeled ASI MON.
To connect to the ASI monitor port, do the following:
Step 1
Locate the BNC ASI connection on the line card (see
Step 2
Screw the barrel of the male BNC connector to the port labeled ASI MON. The connection should be
snug but not overly tight.
Step 3
Connect the other end of the cable to the test equipment according to the instructions for that equipment.
Cisco RF Gateway 10 Hardware Installation Guide
6-36
Removing an SFP Transceiver Equipped with a Bale-Clasp Latch
Chapter 6
Cabling the Cisco RFGW-10 UEQAM
Figure
1-12).
OL-16264-04