Download Print this page

Cisco ADSL Gateway Quick Installation Manual

Linksys adsl gateway

Advertisement

Quick Links

There are two ways to set up the Gateway, run the
Setup CD-ROM or use this Quick Installation. Linksys
strongly recommends that you run the Setup CD-ROM.
Run the Setup CD-ROM
Insert the Setup CD-ROM into the CD-ROM
drive, and follow the on-screen instructions.
Use this Quick Installation
Follow the instructions in this Quick
Installation. This method should only be
used if you cannot run the Setup CD-ROM.

QUICK INSTALLATION GUIDE

ADSL Gateway

Advertisement

loading

Summary of Contents for Cisco ADSL Gateway

  • Page 1: Quick Installation Guide

    QUICK INSTALLATION GUIDE ADSL Gateway There are two ways to set up the Gateway, run the Setup CD-ROM or use this Quick Installation. Linksys strongly recommends that you run the Setup CD-ROM. Run the Setup CD-ROM Insert the Setup CD-ROM into the CD-ROM drive, and follow the on-screen instructions.
  • Page 2: Installation

    Installation Make sure that all the devices that you are working with are powered down, including your computer(s) and the Gateway. If you have a modem connected to your network, disconnect it. The Gateway replaces your modem. Connect one end of the provided Ethernet cable to your computer’s Ethernet adapter.
  • Page 3 Connect the power adapter to the Gateway’s power port and the electrical outlet. Power on the computer that you want to use to configure the Gateway. Conexão da alimentação The Power, Wireless, and at least one of the numbered Ethernet (1, 2, 3, or 4) LEDs should light up.
  • Page 4 For the Virtual Circuit, enter the VPI and VCI settings. Proceed to the appropriate instructions for your Encapsulation method. Enter the following settings unless otherwise instructed by your ISP. Encapsulation Settings by Country Country Encapsulation Multiplexing Australia PPPoE New Zealand PPPoA PPPoA RFC 2364 PPPoA or RFC 2516 PPPoE...
  • Page 5 RFC 1483 Routed or IPoA Enter the IP Address, Subnet Mask, and Default Gateway IP address. In the Primary and/or Secondary DNS fields, enter at least one DNS IP address. Save Settings. Click RFC 1483 Routed IPoA RFC 1483 Bridged - Dynamic IP Address For the IP Setting, select Obtain an IP Address Automatically.
  • Page 6: Save Settings

    Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2008 Cisco Systems, Inc. All rights reserved. Other brands and product names are trademarks or registered trademarks of their respective holders.

This manual is also suitable for:

Linksys rfc 1483Linksys rfc 2364