Table of Contents
Advertisement
Chapter 3
Cisco RFGW-10 UEQAM Installation
Note
Do not overtighten the cable management captive screws when using a Phillips screwdriver. Tighten to
5-in lbs torque maximum.
Figure 3-17
Figure 3-17
1
2
3
1 Chassis rear left side panel
2 Cable-management bracket captive screws
Connecting Power to Cisco RFGW-10 UEQAM
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit
without the covers installed. Statement 1077
OL-16264-04
shows the cable-management brackets attached to the chassis.
Installing the Cable-Management Bracket
Connecting Power to Cisco RFGW-10 UEQAM
3 Cable-management bracket
Cisco RF Gateway 10 Hardware Installation Guide
3-21
Advertisement
Table of Contents
