Cisco RFGW-10 Hardware Installation Manual page 149

Chapter 6 Cabling the Cisco RFGW-10 UEQAM
Figure 6-7
Step 2
Align the end pins on the UCH with the pin holes in the faceplate.
Figure 6-8
Caution
While replacing the UCH, be careful not to bend the cables in the holder at right angles.
Step 3
While holding the UCH and the cables in place on the faceplate, use your fingers to tighten the lead
screw. If the UCH and cables do not set securely in place on the faceplate, wiggle the holder to set the
connectors.
Step 4
Use the flathead screwdriver to tighten the lead screw. Turn the lead screw clockwise until it no longer
turns (10 in-lbs, maximum torque 15 in-lbs).
OL-16264-04
Aligning the UCH with the RF Switch Card Dense Connector Ports
Red line
Installing the UCH on the Faceplate
Installing the UCH on the Cisco RFGW-10 UEQAM RF Switch Card
Cutout
Cisco RF Gateway 10 Hardware Installation Guide
Shroud
Lead screw
6-9