Connecting Input Power To The Chassis; Connecting A Terminal Or Pc To The Console Port - Cisco VG202 Hardware Installation Manual

Connecting Cables
crosses. On-premise wiring is protected from power line crosses by a device that provides
overcurrent and overvoltage protection. Nevertheless, if the on-premise wiring is in close proximity
to, or not shielded from, the off-premise wiring or power cables during a lightning strike or power
surge, the on-premise wiring can carry a dangerous discharge to the attached interface, equipment,
and nearby personnel. Statement 338

Connecting Input Power to the Chassis

Procedure
Connect the chassis to an AC power outlet as shown in
Step 1
Figure 3-6
1
3
To secure the power cord to the voice gateway, attach the power lock clip to the power cord, and slide
Step 2
the clip to the end of the DC plug. See location 1 in

Connecting a Terminal or PC to the Console Port

Connect a terminal or PC to the Console Aux port either to configure the software by using the
command-line interface (CLI) or to troubleshoot problems with the voice gateway.
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
3-10
Connecting the External Power Supply to the Cisco Voice Gateway
V G 20 4
Fa stE the rne
t CO NS OL E
FX S
0/1
0/0
AU X
0/3
0/2
0/1
0/0
12 V DC
2
4
Power lock clip
Power adapter
Figure
SA
1
3
2
Power cord
4 AC plug
Figure
Chapter 3 Installing the Voice Gateway
3-6.
3-6.
OL-15959-01