Honda TRX400EX FOURTRAX 1999 Service Manual page 212

HYDRAULIC DISC BRAKE
Install the pad spring as shown.
If the pin boots are hard or deteriorated, replace
them with new ones.
Install the bracket pin boot into the caliper body and
pack silicone grease to the inside of the boot.
Apply silicone grease to the grease groove in the
slide pin.
Install the slide pin boot and the slide pin so the boot
ribs properly align with the grooves in the caliper
body and slide pin.
Install the caliper bracket over the caliper body with
the spring washer (between the slide pin and bracket)
and thread the slide pin into the bracket, being care-
ful not to damage the pin boot.
Make sure that the boots are seated securely into the
pin grooves.
Install the brake pads (page 14-5).
Tighten the slide pin and install the dust plug.
TORQUE: 23 N m (2.3 kgfm,
Connect the brake hose to the brake caliper with the
oil bolt and new sealing washers, and tighten the oil
bolt by aligning the hose joint with the stopper
groove.
TORQUE: 34 Nm (3.5 kgfm, 25 Ibf.ft)
Fill and bleed the front brake hydraulic system (page
14-3).
Install the front wheel (page 12-91,
2
17