HYDRAULIC DISC BRAKE
Connect the push rod t o the brake pedal with the
joint pin and secure
Fill and bleed the rear hydraulic system (page 14-3).
REAR BRAKE CALIPER
CAUTION:
Avoid spilling fluid
parts. Place a rag over these parts whenever the sys-
tem is serviced.
DISASSEMBLY
Drain the brake fluid from the rear brake hydraulic
system (page 14-3).
Loosen the lock nut and remove the adjusting bolt
and brake arm. Disconnect the brake lock cable from
the brake arm and remove it from the cable stay.
Remove the two bolts and parking brake base.
Remove the O-ring.
Disconnect the brake hose from the rear brake caliper
by removing the oil bolt and sealing washers.
Loosen the caliper slide pin,
Remove the brake pads (page 14-6).
Loosen the slide pin and remove the following:
-caliper bracket and washer
- pad spring
pin and boots
-caliper piston
14-1 6
it
with a new cotter pin.
on
painted, plastic
or
rubber
ADJUSTING
BOLT
B
RM