Honda TRX400EX FOURTRAX 1999 Service Manual page 191

Drive in a new right bearing (brake disc side) squarely
with the marking side facing up until it is fully seated.
Install the distance collar.
Drive in a new left bearing squarely with the marking
side facing up until it is fully seated.
TOOLS
Driver
Attachment, 62
x 68 mm
Pilot, 40
Clean the bearing holder outer surface and the
swingarm inner surface.
Coat new O-rings with oil and install them into the
grooves in the bearing holder.
Apply grease to the bearing holder outer surface.
Install the bearing holder into the swingarm until it is
fully seated, being careful not to damage the O-rings.
Coat new O-rings with oil and install them into the
caliper stay groove and onto the bearing holder.
Install the bushing onto the stopper bolt.
Apply grease to the inner surface of the caliper stay
and install the stay onto the bearing holder and bush-
ing.
Install the snap ring into the bearing holder gropve
with the "OUT SIDE" facing out to secure the caliper
stay.
Pack 1 g (0.04 oz) of grease into each new dust seal
lip cavity.
Install the dust seals until they are flush with the
bearing holder
07749-0010000
07746-0010500
a
REAR WHEELlSUSPENSlON
ATTACHMENTA ND
-
13-7
PILOT
-
STAY