Honda TRX400EX FOURTRAX 1999 Service Manual page 219

Install the caliper bracket over the caliper body with
the spring washer (between the slide pin and bracket)
and thread the slide pin into the bracket, being care-
ful not to damage the pin boot.
Make sure that the boots are seated securely into the
pin grooves.
Install the brake pads (page 14-61,
Tighten the slide pin.
TORQUE
23 N.m 12.3 kgf.m, 17 IbfW
Connect the brake hose to the brake caliper with the
oil bolt and new sealing washers, and tighten the oil
bolt.
TORQUE: 34 N.m (3.5 kgf.m, 25 IbfW
Fill and bleed the rear brake hydraulic system (page
Apply silicone grease to the brake shaft outer sur-
face.
Position the shaft so that its punch mark is within the
reference marks on the base and thread it.
Screw the shaft in fully and make sure that the punch
The brake shaft
mark is within the reference marks.
has left-hand
threads.
If the shaft boot is hard or deteriorated, replace it
with new one. Install the boot over the brake base
and into the shaft groove properly.
brake base onto the ca iper body w'th the two bolts.
TORQUE: 23 N.m 12.3 kgf.m. 17 IbfW
HYDRAULIC DISC BRAKE
SLIDE PIN
14-19