Honda TRX400EX FOURTRAX 1999 Service Manual page 183

Install the tie-roo into the steer ng shaft and knuckles
with the flat lwrench holding point1 side facing the
knuckle.
Install the joint nuts and tighten them by holding the
joint stud flat surfaces.
TORQUE 44 N.m 14.5 kgf.m, 33 IbfW
If the ball joints were replaced, tighten the lock nuts
following procedure:
Rotate both ball joints with the tie-rod axis until they
stop against the ball joint studs. Hold them in that
position and tighten the ball joint lock nuts.
TORQUE: 54 N m 15.5 kgfm, 40 Ibf4t)
. -
Install new cotter pins into the tie-rod ball joint studs.
CAUTION:
Do not twist
Install the handlebar assembly onto the steering
andcableprop-
Tighten the nuts.
TORQUE: 39 Nm 14.0 kgf.m, 29 IbfW
Install the cables and wire harness into the guide on
the shaft holder.
Install the brake hose onto steering shaft holder with
the clamp bolt.
Adjust the toe (page 3-20).
Install the front fender (page 2-2).
bend the brake hose and
or
FRONT WHEELlSUSPENSlONlSTEERlNG
,
NUT
pipe.
C
I
12-21