FUEL TANK & HEAT PROTECTOR
Remove the front fender (page 2-2).
FUEL TANK
Turn the fuel valve OFF.
Disconnect the fuel tube from the fuel valve.
Unhook the mounting straps.
Remove the two mounting bolts and the fuel tank.
TANK UNDER HEAT PROTECTOR
Remove the carburetor air vent tube from the tube
holder in the heat protector.
Remove the clutch cable from the cable guide on the
protector.
Release the trim clip by raising the center pin and
remove it.
Remove the fuel tube from the protector rubber.
Remove the two mounting bolts.
Release the two tabs on the rear side of the protector
and remove the protector from the frame.
When installing
Installation is in the reverse order of removal.
the trim clip,
After installation, turn the fuel valve ON and check
carefullyalign
the fuel line for leakage.
the clip holes
avoid damaging
the clip.
2-4
MOUNTING BOLT
BOLTS
GUIDE
AIR VENTTUBE
AT PROTECTOR
TRIM CLIP