Front Shock Absorber - Honda TRX400EX FOURTRAX 1999 Service Manual

FRONT WHEEL/SUSPENSlON/STEERING
Install the knuckle onto the upper and lower arms
with the joint nuts, washer and clamp.
Tighten each nut to the specified torque and further
tighten until its grooves align with the cotter pin hole.
TORQUE:
Install new cotter pins.
Install the following:
- tie-rod into knuckle (page 12-7)
- wheel hub and front wheel (page 12-81,
Adjust the toe (page 3-22).

FRONT SHOCK ABSORBER

REMOVAL
Support the vehicle with
front wheels
Support the lower arm and remove the upperllower
mounting nuts, bolts and shock absorber.
INSPECTION
Remove the lower pivot collar and dust seals.
Check the pivot collar and dust seals for wear or
damage.
12-1 6
29
a support block to raise the
off
the ground.
\
'INS
WAS HER
DUST SEALS