Installation With Wall Mount Bracket(Mao/Mai) - LEGRAND 430 521 Instruction Manual

2.7 Installation with Wall Mount Bracket (430 523/430 524/430 525 Models)
① Make a hole whose diameter is
30~40mm on the mounting surface to
pass the wire(s) and cable(s)
through the mounting surface. (In
case of the wiring and cabling
through the mounting surface only)
Then prepare the wall mount bracket.
Pull the wire(s) and cable(s) for
the system as below. Attach the wall
mount bracket to the mounting
surface. (Hex Lag #14 50)
③
Screw the dome cover to the main
body and remove the protection vinyl
from the dome cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set
up properly.
② Pull the wire(s) and cable(s) for the
system as below. Wire the cable(s) to
the ports. Insert the mounting hooks
into the holes on the surface of the
main body and turn the main body.
Assemble the main both with the camera
mount adaptor with the 3 screws.
(Machine M5 15)
33