Table of Contents
Advertisement
_________________________________________________________________________________
2.6
Installation with Ceiling Mount Bracket (430 523/430 524/430 525 Models)
①
Remove the ceiling tile from the
ceiling and cut a hole whose
diameter is 30~40mm on the ceiling
tile to pass the wire(s) and
cable(s) through to the upside of
the ceiling. (In case of the wiring
and cabling through the mounting
surface only) Then prepare the
ceiling mount bracket. Pull the
wire(s) for the system as below.
(Anchor Bolt 3/8" 70)
③ Screw the dome cover to the main
body and remove the protection vinyl
from the dome cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set
up properly.
To adjust the installation height from the mounting surface, the pipe and coupler
should be needed between the surface mount part of the ceiling mount bracket and
the camera mount part of the ceiling mount bracket. Note that they are not supplied
by the manufacturer.
② Pull the wire(s) and cable(s) for the
system as below. Wire the cable(s) to
the ports. Insert the mounting hooks
into the holes on the surface of the
main body and turn the main body.
Assemble the main both with the camera
mount adaptor with the 3 screws.
(Machine M5 15)
32
Advertisement
Table of Contents
