Table of Contents
Advertisement
3.5
Preset
Function
Setting Presets
Running Presets
Deleting Presets
3.6
Swing
Function
Setting Swings
Running Swings
MAX. 127 positions are programmable. The Preset number
can be assigned from 1 to 128 except 95. Preset 95 is
reserved for entering into OSD menu. Camera parameters
such as White Balance, Auto Exposure and others can be
set up independently and each preset can have its own
parameter values independently from the other persets.
When setting up presets with a controller, Label should
be blank and "Camera Adjust" should be set to "GLOBAL" as
the default. To change the parameters, enter into OSD
menu.
Set Preset [1~128]
Go Preset [1~128]
To delete Presets, enter into OSD menu.
This function is that the camera moves repetitively between two
preset positions at programmed speeds. When a swing function
runs, the camera moves from the preset assigned as the 1st
point to the preset assigned as the 2nd point in CW(Clockwise)
direction. Then the camera moves from the preset assigned as
the 2nd point to the preset assigned as the 1st point in
CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point and the
preset assigned as the 2nd point are same, the camera turns
on its axis by 360 in CW(Clockwise) direction and then it
turns back on its axis by 360 in CCW (Counterclockwise)
direction. The Swing speed is defined from 1 /sec to
180 /sec.
To set Swing, enter into OSD menu.
Method 1) <Run Pattern> [Swing
NO. + 10]
Method 2)
<Go
45
ex) Run Swing 3 : <Run
Pattern> [13]
ex) Run
Swing 3
Advertisement
Table of Contents
