Pattern Setup - LEGRAND 430 521 Instruction Manual

_________________________________________________________________________________
4.9

Pattern Setup

 Pattern Number
 Clear Pattern
 Run Pattern
 Edit Pattern
Pattern Edit
1) With the Joystick of your controller, move the camera to the start position with an
appropriate zoom magnafication. To start the pattern recording, press NEAR key. To
exit, press FAR key.
2) Move camera with joystick of controller or run preset function to memorize the path
(mostly curve path) in the selected pattern.
movement will be memorized in a pattern. After a pattern is programmed, the remaining
storage is displayed in progress bar on the screen.
3) To save the data and exit, press NEAR key. To cancel saving the data and delete the
data, press FAR key.
[1~4 ]
Selects a Pattern number to edit. If the
selected pattern number is not defined,
"UNDEFINED" will be displayed under the
selected pattern number.
[CANCEL/OK]
Deletes the data of the selected pattern.
Runs the Pattern for the test purposes to
check if it works properly.
Edits the selected pattern.
70
The movement by Joystick and preset