Installation With Wall Mount Bracket (4 305 23/4 305 24/4 305 25 Models) - LEGRAND 4 305 21 User Manual

2.9 Installation with Wall Mount Bracket (4 305 23/4 305 24/4 305 25 Models)

①
Make a hole whose diameter is 30~40mm on the
mounting surface to pass the wire(s) and cable(s) through
the mounting surface. (In case of the wiring and cabling
through the mounting surface only) Then prepare the wall
mount bracket. Pull the wire(s) and cable(s) for the system
as below. Attach the wall mount bracket to the mounting
surface. (Hex Lag #1450)
③
Screw the dome cover to the main body and
remove the protection vinyl from the dome cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
②
Pull the wire(s) and cable(s) for the system as
below. Wire the cable(s) to the ports. Insert the mounting
hooks into the holes on the surface of the main body and
turn the main body. Assemble the main both with the
camera mount adaptor with the 3 screws. (Machine M515)
26