Table of Contents
Advertisement
3.7
Pattern
Function
Setting Patterns
Running Patterns
Deleting Patterns
Note: When the system memorizes Patterns, the commands are stored in the momories,
not the positions of Pan/Tilt/Zoom. Hence there might be small differences between
the original path and the revived path by path type of Patterns. Note that it is not
a problem in position precision.
This function is that the camera memorizes the path
(mostly curve path) by the joystick of the controller and
revives the trajectory operated by joystick as closely as
possible.
MAX. 4 Patterns are programmable and Maximum 1200
communication commands can be programmed in a pattern.
A Pattern can be created by the following methods.
Method 1) <Set Pattern> [Pattern NO.]
The Pattern programming window appears on the
monitor as below.
The movement by Joystick and the preset
movement can be memorized in a pattern.
After a pattern is programmed, the remaining
storage is displayed in progress bar on the
screen.
To save the recording, press NEAR key and to
cancel, press FAR key.
Method 2) Programming in OSD Menu : See the section "How to use
OSD Menu".
Method 1) <Run Pattern>
[Pattern NO.]
Method 2) <Go Preset> [Pattern
NO. + 130]
To delete Patterns, enter into OSD menu.
47
Ex: Run Pattern 2 : <Run
Pattern> [2]
Ex: Run Pattern 2 : <Go
Preset> [132]
Advertisement
Table of Contents
