Dip Switch Setup - LEGRAND 430 521 Instruction Manual

_________________________________________________________________________________
DIP Switch Setup (430 522 model)
Before you install the camera, you should set the DIP switches to configure the
camera ID, communication protocol. Do not use the ISP connector. (Authorized person
only !)
Camera ID Setup

ID number of camera is set using binary number. The example is shown bellow.
Pin 1
ID Value 1
ex: ID=5 on
ex: ID=10 off

The range of ID is 1~255. Do not use 0 as camera ID. Factory default of Camera ID is
1.

If you want to control a certain camera, you must match the camera ID with Cam ID
setting of DVR or Controller.
2 3 4 5
2 4 8 16
off on off off
on off on off
6 7 8
32 64 128
off off off
off off off
20