Installation With Surface Mount Bracket (Mps) - LEGRAND 430 521 Instruction Manual

_________________________________________________________________________________
2.3 Installation with Surface Mount Bracket
① Remove the ceiling tile from
the ceiling and cut a hole
whose diameter is 30~40mm on
the ceiling tile to pass the
wires and cables through to the
upside of the ceiling. (In case
of wiring and cabling through
the ceiling tile only)
③
Connect the wires and cables to
the ports and install the main
body. (Machine M3 8)
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set
up properly.
When the pipe hole for wiring and cabling on side of the Surface Mount Bracket is
not used, make sure that the hole is properly sealed with the supplied Hole Plug.
(430 521 Model)
② Prepare the surface mount bracket. Pull the
wires and cables for the system as below.
Attach the surface mount bracket to the
mounting surface. (Tapping M4 25)
④ Align the dome cover stud with the dome
cover assembly stud and slightly push the
dome cover to the ceiling. Turn the dome
cover clockwise and screw on the dome cover
lock-up screw. Then remove the protection
vinyl from the dome cover. (Machine M3 6)
26