Direct Installation On The Ceiling - LEGRAND 430 522 User Manual

DIRECT INSTALLATION ON THE CEILING

a To pass cables to upside of ceiling, please, make
about 50~60mm hole on the ceiling panel.
&
&
c After assembling the Rubber Gasket to the
&
Terminal Cover, install Terminal Cover on ceiling
tex and connect cables to terminal blocks.
e Check the 2 mold line for assembly before starting
assembly. Line up the mold lines as shown in
the dotted circle and turn main body on its axis
in CW(Clock-Wise) direction and assemble main
body to Terminal Cove
b For cable connection, remove the pre-defined hole
mark on the Rubber Gasket and locate the summit
of the Plate Spring at the arrow mark as shown in
the dotted circle.
'
'
d Connect the "Drop Prevention Spring" to the main
'
body to prevent camera from drop.
'
#
#
f Tighten the Lockup Screw as shown bellow.
10