Configuring Rip To Advertise A Summary Route - HP MSR Series Configuration Manual

The output shows that only one RIP route reaches network 1.1.5.0/24, with the next hop as Router
B (1.1.1.2) and a cost of 2.

Configuring RIP to advertise a summary route

Network requirements
As shown in
RIP. Configure RIP to redistribute OSPF routes on Router C so Router D can learn routes destined for
networks 10.1.1.0/24, 10.2.1.0/24, 10.5.1.0/24, and 10.6.1.0/24.
To reduce the routing table size of Router D, configure route summarization on Router C to advertise only
the summary route 10.0.0.0/8 to Router D.
Figure 8 Network diagram
Eth1/2
11.4.1.2/24
Router D
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic OSPF:
# Configure Router A.
<RouterA> system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 10.5.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] network 10.2.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] network 10.6.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
# Configure Router C.
1.1.2.0/24, cost 0, nexthop 1.1.2.1, Rip-interface
1.1.3.0/24, cost 1, nexthop 1.1.1.2
1.1.4.0/24, cost 2, nexthop 1.1.1.2
1.1.5.0/24, cost 2, nexthop 1.1.1.2
Figure 8, Router A and Router B run OSPF; Router D runs RIP; and Router C runs OSPF and
Eth1/3
10.1.1.2/24
Eth1/2
11.3.1.1/24
Router C
RIP
Eth1/1
11.3.1.2/24
Eth1/2
Eth1/1
10.6.1.2/24
10.1.1.1/24
Router B
Eth1/2
Eth1/1
10.5.1.2/24
10.2.1.2/24
Eth1/1
10.2.1.1/24
Router A
41
OSPF