Table of Contents
Advertisement
Chapter 2: Basic Checkout
Preparing The 7545 For Operation
2.2
Preparing The 7545 For Operation
Typically, 7545 Hand-Held Computers are configured at the factory and arrive ready for use.
Although these computers are equipped with an internal Compact Flash and SD I/O slot,
these slots are not intended for user modification. If a device needs to be changed or added
in these slots, contact qualified Psion Teklogix personnel.
2.2.1
Equipment You Need To Get Started
You'll need:
• A compatible battery charger, docking station or portable docking module (PDM)
with power supply.
• An operating wireless network (if you are not operating the equipment in
batch mode).
• A medium (#2) Phillips head screwdriver (if you need to attach a carrying strap or
pistol grip handle).
2.3
Powering Up The 7545
Note: Psion Teklogix offers a Portable Docking Module (PDM) along with its power sup-
ply to help speed the checkout and confirmation process for your 7545. The PDM
can power your computer with or without a battery installed in the unit. Refer to
Chapter 6: "Peripheral Devices & Accessories" for more information about
this accessory.
2.3.1
Charging The Battery
Important: The 7545 uses a high capacity lithium-ion battery. Before charging the bat-
Batteries shipped from the factory are not charged. They must be fully charged prior to use.
Full capacity may not be reached until at least 5 full charge/discharge cycles have been per-
formed. Batteries can be charged using a gang charger or the unit's internal charger. When
using the internal charger, a suitable power source is required. All chargers and docking sta-
tions are described in Chapter 6: "Peripheral Devices & Accessories".
14
Psion Teklogix 7545 Hand-Held Computer User Manual
Preliminary Draft 3
tery, it is critical that you review the battery safety guidelines in the 7545
Hand-Held Computer Regulatory & Warranty Guide (PN 8000191).
Advertisement
Chapters
Table of Contents
