Psion Teklogix 7530 User Manual page 262

Arrows
The "Arrows" parameter assigns one of three possible functions to the two arrow
keys on the Scan-See keyboard:
Value
"Bright"
"Horiz"
"Vert"
Note: For "Horiz" and "Vert," changing the offset will take affect only after the
7535 display has been updated.
Version
Scan-See units with serial numbers that read 1594120224 or higher contain
firmware that implements a different communication protocol with the 7535
than older units. The "Version" numbers represent the following unit versions:
Value
• First LED version – up to serial number 1594080275; these are
0
encased in grey plastic.
• Model 7000 LED units – versions after the serial number above;
1
these are also encased in grey plastic.
• Metrologic 7000M LCD units; these are encased in grey plastic.
2
• Psion Teklogix 7000M LCD units; these are encased in black plastic.
Note: To interface the 7535 to the Scan-See units with older firmware
(serial number lower than 1594120224), set "Parity = space";
all other parameters are identical to the newer firmware.
XON/XOFF
Important: IF YOU ARE USING TRANSCEIVERS WITH YOUR
SCAN-SEE, this parameter must be set to "Y".
Arrow keys control Scan-See display brightness
Arrow keys control "Column Offset"
Arrow keys control "Line Offset"
Table 6.6 "Arrow" Parameter Options
Scan-See Version
Table 6.7 Scan-See Versions
Psion Teklogix 7530 Hand-Held Computer User Manual
Chapter 6: Tekterm Application
Scan-See Sub-Menu – Mapping The Viewport
Function
243