Switching The 7530 Hand-Held On And Off - Psion Teklogix 7530 User Manual

Chapter 3: Getting To Know Your 7530

Switching The 7530 Hand-Held On And Off

• Combo Docking Station (Model #HU4002) – operates as both a charger
and a docking station. Operating as a charger, both the battery installed in
the computer and a spare battery can be charged simultaneously.
• Quad Docking Station (Model #HU4004) – can charge the battery of up to
four 7530s inserted in the docking station while transferring data through an
Ethernet connection.
• Powered Cradle (Model #HU1000, HU1010) – can charge the 7530 with
the battery installed in the hand-held.
It can take from 1.5 to 4 hours to charge a battery. The 7535's intelligent charging
system protects the battery from over-charging by terminating the charge process
when the battery is at maximum capacity.
Note: Refer to "Monitoring The Battery And Maximizing Run Time" on page 53
for additional information about the 7530 battery.
Important:

3.3 Switching The 7530 Hand-Held On And Off

Switching On The 7530
• Press and hold down the <ENTER/ON> key for at least one second.
• When all four LEDs flash orange, release the <ENTER/ON> button.
A splash screen displaying the Psion Teklogix logo and the Microsoft®
Windows® CE. net logo appears followed by the startup desktop.
Note: If the 7530 is in suspend state, pressing <ENTER/ON> key 'wakes' the
unit from this state. The screen in which you were working before the
computer entered suspend state is displayed.
34
Psion Teklogix 7530 Hand-Held Computer User Manual
To avoid damaging the battery, chargers will not begin the charge
process until the battery temperature is between 0˚C (32˚F) and
39˚C (102˚F). If the battery is too hot or cold, the battery status
LED flashes yellow and the charge is suspended. Refer to
Table 3.1, "Charge LEDs" on page 43 for details.