Canon i-SENSYS MF6140dn User Manual page 820

If sending a fax, reduce the resolution to scan the document.
Action 4
"Changing the Scan Settings (Fax)"
#099
Problem Printing, sending, or receiving was canceled.
When you cancel an operation, this error code is displayed, but this is not abnormal. Print, send, or
Action
receive documents again as necessary.
#401
Problem A scanned document could not be stored to a USB memory device due to insufficient memory space.
Delete unnecessary data to free space in the USB memory device or connect a different USB memory
Action
device.
#404
Problem Tried to save a document to USB memory, but writing to the USB memory is restricted.
USB memory with a security function cannot be used. If the USB memory setting does not to allow writing,
Action
cancel the setting and try to save the document again.
#406
Problem A scanned document could not be stored to a USB memory device due to an error.
Remove the USB memory device, and insert it again.
Action 1
"Basic Scan Flow (Saving to USB Memory Device)"
Action 2 Reduce the number of pages in the scan original.
Make sure that USB memory is formatted with a file system that is supported by the machine (FAT16 or
Action 3
FAT32).
#408
Problem 1 USB memory was disconnected while being read from, and reading failed.
Check if USB memory is disconnected, and try reading again.
Action
"Printing Fundamentals (USB Memory)"
Problem 2 An error occurs when reading or accessing images on USB memory, and images cannot be read normally.
Action Check USB memory status, and then repeat the operation.
Problem 3 The connected USB memory is formatted with an unsupported file system.
Make sure that the USB memory is formatted with a file system that is supported by the machine (FAT16
Action
or FAT32).
#701
Authentication failed because an incorrect Department ID or PIN was entered when the Department ID
Problem 1
Management was activated.
Downloaded from ManualsPrinter.com Manuals