Canon i-SENSYS MF6140dn User Manual page 854

Problem No destination is registered in the one-touch key or coded dial code that you pressed.
Register a destination.
Action "Registering and Editing One-Touch Keys"
"Registering and Editing Coded Dial Codes"
<No response from host.>
Problem The machine was found unconnected to the network when checking.
Connect the machine to the network and properly configure the connection.
Action
See the Getting Started.
<No response.>
Problem The recipient's machine did not respond within 35 seconds.
Contact the recipient and ask them to send the fax again. After you confirm the beep, select <Start
Action
Receiving> and press [OK].
<Number is incorrect. Enter again.>
Problem You entered an incorrect Department ID and PIN.
Enter the correct numbers. For details, see the following.
Action
"Specifying the Setting for Department ID Management"
<Numbers do not match. Enter the numbers again.>
The number that you entered for confirmation does not match the number that you first entered. This
Problem message appears when <Fax No. Confirmation Re-Entry> in <Restrict TX Function> in <System Settings>
is set to <On>.
Action Make sure to enter the same number.
<Open authentication failed. Check WEP settings.>
Connection failed because the machine uses "open system" authentication while the wireless LAN router
Problem 1
or access point used is set to "Shared Key" authentication.
Change the WEP authentication method on the machine to <Shared Key> accordingly and configure
the settings manually.
"Setting by Manually Entering SSID"
Action
For information on how to check the network key (WEP key), refer to the instruction manual of the
wireless LAN router or access point, or contact the manufacturer.
The connection failed because the machine restricted the MAC address and the MAC address filtering
Problem 2
was set with the wireless LAN router or access point you are using.
Change the MAC address for the machine and the computer you are using to the allowed settings.
For information on how to set MAC address filtering, refer to the instruction manual of the wireless
Action
LAN router or access point, or contact the manufacturer.
<Paper jam.>
Downloaded from ManualsPrinter.com Manuals