Canon i-SENSYS MF6140dn User Manual page 789

Port Number Settings
MTU Size
SNMP Settings
You can monitor and control the machine using an SNMP-enabled device.
"Monitoring/Controlling Devices by SNMP (SNMP Setting)"
Settings
SNMPv1 Settings
SNMPv3 Settings
Printer Management
Information From Host
Dedicated Port Settings
Set to enable or disable the dedicated port.
If the dedicated port is set to be disabled, you cannot scan/print, or configure/check the settings for this product when
using the printer driver or the MF Toolbox by connecting the network.
Off, On
"Setting the Dedicated Port"
Downloaded from ManualsPrinter.com Manuals
Off, On
"Setting the Permission for HTTP Communications"
Depending on your network environment, you can change the port number for each protocol.
LPD: 1 to 515 to 65535
RAW: 1 to 9100 to 65535
HTTP: 1 to 80 to 65535
POP3 RX: 1 to 110 to 65535
SMTP TX: 1 to 25 to 65535
SNMP: 1 to 161 to 65535
WSD Search: 1 to 3702 to 65535
Multicast Discovery：1 to 427 to 65535
"Setting Protocol Port Numbers"
Select MTU.
1300, 1400, 1500
Specify whether to use SNMPv1, and set the Community Name and access rights used by
SNMP.
Off
On
Community Name 1: Public
Community Name 2: Not Set
MIB Access Permission 1: Read Only, Read/Write
MIB Access Permission 2: Read Only, Read/Write
Dedicated Community Settings: Off, Read/Write, Read Only
"Setting SNMPv1"
Specify whether to use SNMPv3.
Off, On
"Setting SNMPv3"
Specify whether to acquire printer management information periodically from host.
Off, On
"Obtaining Printer Management Information from Host"
Descriptions