Table of Contents
Advertisement
Gruop 1
Flux:
In the last programming of coffee doses, the system
memorizes the flow speed of the water during delivery.
If "flux mode" is activated, the deliveries are controlled
by the system and are considered valid when the speed
of delivery is within the tolerance set. If the delivery
speed is too fast or too slow, the system will display a
message suggesting to increase or decrease the grind
of the coffee (see table below).
The adjustment bar, allows to set the tolerance value
(Range: 0 ÷ 50%).
LIGHT
DESCRIPTION
Dispensing too slow.
Dispensing within the tolerance parameters
Dispensing too fast
i
By setting the "FLUX" mode, the machine will
only check the coffee dose keys. The "STOP/PROG"
key, if used for delivery, will not be subject to flux
verification.
46
12.15 Programming group washing
To program the automatic notification
of delivery group washing request
proceed as follows:
• Pressing "Group washing" displays the
Group washing
screen below.
Group washing
Start On
Hour
Cycles
Start On:
Enable or disable the request for automatic washing
of the groups at machine start-up.
Hour:
Sets the time at which the request is sent for washing
groups.
Cycles:
This parameter controls the number of cycles of water
supply during the washing.
On completion of the wash cycle set, the display will
request the rinsing of the filter holder.
To perform cleaning operations, proceed as
i
indicated in chapter "Group washing". When the
machine is turned on, after the temperature
raises to operating levels, if set to YES, the display
shows the washing request. to disable the washing
request, set time to 00:00.
Technical manual
Advertisement
Table of Contents
