Table of Contents
Advertisement
5.
Turning the machine on
5.1
First time on
Before turning on the machine, make sure the drain
pad (2) located under the cup support grid is correctly
connected to the sewer.
Turn on the machine using the main switch (1) and
follow the indications on the display of the machine.
1
2
When the machine
is turned on, it performs
the functional test and
reports information
regarding the software
installed.
• XX.XX.XXXX : revision date
• RY : revision number
O.K. indicates that
the machine is working
correctly.
In case of negative
r e s u l t , c h e c k t h e
message on the display.
When the machine
is turned on, it will
activate the motor
pump installed and
begin to fill the services
boiler and the water heaters for the coffee (present in a
number equal to the number of delivery groups installed
on the machine.)
28
FUNCTIONAL TEST
EVPLUS XX/XX/XXXX RX
TEST
-O.K.-
COFFEE
WATER FILLING
In order to bleed
any air present in the
heaters, each time the
machine is turned on
the solenoid valves of
the groups will be activated, making water and steam
come out from the perforated disk of each group for
about 10 seconds.
When the heating phase of the delivery groups
has finished (after about 10 minutes), signaled by the
disappearance of the "PLEASE WAIT" indication, it will be
possible to make the coffee selections. For the delivery
of hot water and steam, it will be necessary to wait for
the complete heating of the services boiler.
Heating in progress
Please wait
During the heating phase of the services boiler (from
95°C to 98°C), the machine will execute a light delivery
of water and steam from the hot water nozzle.
The delivery of steam and hot water, and thus the
full operation of the machine, will be possible only at a
pressure (
) higher than 0.6 bar.
MAKE ATTENTION
WATER/STEAM ESCAPE
Technical manual
Advertisement
Table of Contents
