Table of Contents
Advertisement
• wait for the washing to be carried out until the fol-
lowing messages appear on the display:
GR.1 REMOVE FILTER
GR.2 ADD DETERGENT
GR.3 ADD DETERGENT
GR.1 STOP/PROG KEY
GR.4 ADD DETERGENT
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
• remove the filter holder from delivery group 1 and
press the "PROG/STOP" key.
• wait for the rinse cycle to be carried out (this takes
roughly 30 seconds), and the following messages will
appear on the display:
GR.1 RINSE
GR.2 ADD DETERGENT
GR.3 ADD DETERGENT
GR.4 ADD DETERGENT
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
• at the end of the rinse cycle, the following messages
will appear on the display:
GR.1 END OF WASHING OK
GR.2 INSERIRE DETERGENTE
GR.3 INSERIRE DETERGENTE
GR.1 END OF WASHING OK
GR.4 INSERIRE DETERGENTE
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
Carry out the washing operations on the other groups,
following the same procedures indicated above.
If you wish, you can force the washing, see chapter
"Programming".
i
The washing operations can also be carried out
simultaneously on several delivery groups. To
exit the washing phase, the washing must be
completed on all the groups.
i
To disable automatic display of the wash request
or to modify the time of activation of the message,
see the chapter "Programming".
48
GR.1 RINSE
13
Settings Menu
From the main menu, pressing the "Settings" button,
gives access to the screens below.
Settings
Update Firmware
Update TFT Disp.
Save data
page 1
Settings
Defaults
Update text
Update Logo
page 2
13.1
Update firmware
This command allows you to upgrade
the machine automation software,
located in the electronic
control unit
Update firmware
To update, press this command, then
the machine will load the new version of the automation
software, located on the USB stick; once finished, check
the new version of the software installed.
Update resources
Load data
Technical manual
Advertisement
Table of Contents
