Table of Contents
Advertisement
A
General warnings
The manufacturer reserves the right to make any
improvements to the product. We guarantee that this
booklet reflects the technical state of the appliance at
the time it is marketed.
We take the opportunity to invite technicians to
make any proposals for improvement of the product or
the manual.
Keep this manual in a safe place. If you lose it you can
ask the manufacturer for another copy.
The manufacturer of the equipment cannot be held
responsible for damage caused by failure to oblige to
the requirements below.
B
Warnings for the installer
• Read this manual carefully. It provides important
information on safe installation, operation and main-
tenance of the equipment;
• Identify the model of the equipment. The model is
shown on the packaging and on the nameplate of
the machine;
• Install the equipment only on sites where there is
good ventilation;
• Do not obstruct the ventilation and exhaust holes on
the machine;
• Do not tamper with the equipment components.
• After removing the packaging, check the condition
of the appliance. If in doubt, do not use it but contact
the retailer directly.
• The packaging material must not be left within the
reach of children, since it is a potential source of dan-
ger. It is advisable to keep the packaging until after
the warranty has expired.
• Identify the model of the equipment. The model is
shown on the packaging and on the nameplate of
the machine;
• Before using the appliance, make sure that the mains
voltage corresponds to the information on the data
plate of the appliance.
• Installation must be done in accordance with the safe-
ty standards in force and by qualified and prepared
personnel. Incorrect installation may be harmful to
people, property or animals.
6
This appliance is to be considered completely
safe only when it is connected to an efficient
earthing system which is in compliance with safety
standards.
The electric system must be equipped with
!
a suitable differential circuit breaker. It is
important to have these requirements checked.
If in doubt, have the system carefully checked by
qualified personnel. The manufacturer cannot be
considered responsible for any damage caused by
an inadequate electric system.
Make sure that the supply power is enough to
supply the necessary energy for the operation of
the machine.
• During installation of the machine, a main switch
must be installed as required by current safety regu-
lations, with a contact opening distance of at least
3 mm.
• It is not advisable to use extensions or electrical
adapters for multiple outlets. If their use is absolutely
necessary, use only simple adapters and extensions
complying with current safety standards. Never ex-
ceed the capacity value indicated on the adapter and
the extension cord, and that the maximum power
indicated on the adapter.
• The espresso coffee appliance is intended for the
preparation of hot beverages such as coffee, tea or
warm milk. This appliance is to be used only for its
intended use. Any other use is considered improper
and therefore dangerous. The manufacturer cannot
be held responsible for any damage caused by an
incorrect and unreasonable use.
• To ensure good efficiency of the machine and its cor-
rect operation, it is essential to follow the manufac-
turer's directions, performing periodic maintenance
and checks of all the safety devices.
• When using the electrical appliance, several safety
standards must be observed:
- do not touch the appliance with wet or damp
hands or feet;
- do not use the appliance if barefooted;
- do not use extensions in rooms where there are
showers or baths;
- do not pull the power cord to disconnect the ap-
pliance;
- do not leave the appliance exposed to atmos-
pheric agents (rain, sun, etc...);
- do not access the inside of the machine;
- do not spill liquids on the machine.
- do not allow the appliance to be used by children
or incapacitated people.
Technical manual
Advertisement
Table of Contents
