Water Supply; Materials To Be Used; Hydraulic Connections; Activation - Astoria Plus4YouTS Use And Maintenance Manual

Espresso coffee maker
Hide thumbs Also See for Plus4YouTS:
Table of Contents

Advertisement

• Make sure that the machine is used in a sufficiently
lit, aerated, and hygienic premise.
• The access spaces to the machine and main switch
must be left clear, in order to allow the user to inter-
vene without any constrictions and be able to leave
the area immediately in case of necessity.
• Do not spray water on the machine to clean it. Clean
daily following the instructions given in this manual.
• Before any maintenance, disconnect the appliance
from the electrical mains through the main switch.
• For daily cleaning, follow the instructions in this
manual.
• The technician must inform the dealer or the manu-
facturer in a timely manner of any problems in the
use or installation of the equipment.
• Any repairs must be done only by the manufacturer
or an authorized service center, using original spare
parts only. If this standard is not observed the safety
of the appliance is compromised and the guarantee
may be void.
• Inside the device is a lithium button battery to prevent
programming data loss.
• The power cord of the appliance must not be re-
placed by the user. If the cord is damaged, turn the
appliance off and contact professionally qualified
personnel only.
• If you decide you are not going to use the appliance
any more it must be disconnected from the power
supply and emptied of water.
• Do not expose your hands or other body parts to the
coffee, steam, or hot water spouts. The steam and
water that exit the nozzles can cause burns.
• When in operation, the steam and hot water noz-
zles and the filter-holder cups are extremely hot and
should be handled with care only in the indicated
parts.
• Cups must be placed on the special cup-heating
surface only after being thoroughly dried.
• The dishes belonging to the machine itself are to be
placed on the cup-heating surface. It is incorrect to
place any other object on this surface.
• The appliance must not be used by people (includ-
ing children) with reduced physical, sensory or men-
tal capacities, or by people without experience or
knowledge, unless they can be supervised or receive
instructions for appliance use from a person respon-
sible for their safety.
• Children must be supervised, to make sure they do
not play with the appliance.
• The coffee maker must be used at a temperature
between 5°C and 40°C.
Technical manual
• Any unauthorized tampering with any parts of the
machine renders any warranty null and void.
B.1

Water supply

The water supply of the appliance must be carried out
with water which is suitable for human consumption,
in compliance with the regulations in force in the
place of installation. The owner/manager of the system
must confirm to the installer that the water meets the
requirements above.
B.2

Materials to be used

During the installation of the appliance, only the
components and materials supplied with the appliance
are to be used. Should the use of other components be
necessary, the installer must verify their suitability to be
used in contact with water used for human consumption.
B.3

Hydraulic connections

The installer must carry out the hydraulic connections
in accordance with the hygiene norms and the hydraulic
safety norms for environmental protection in force in the
place of installation.
B.4

Activation

When installation is complete, the appliance has to be
started, brought to the nominal working condition and
left in the "ready to operate" condition for 30 minutes.
Afterwards, the appliance has to be turned off and
emptied of the first water introduced in the whole
hydraulic circuit, to eliminate possible initial impurities.
Then, the appliance must be once again loaded and
brought to the nominal working conditions.
After reaching the "ready to operate" condition, the
following has to be performed:
7

Advertisement

Table of Contents
loading

Table of Contents