Programming; Displaying Information - Astoria Plus4YouTS SAEP Use And Maintenance Manual

6.5.3

Programming

Each dose must be programmed with freshly
ground coffee and not with previously-used coffee
grounds.
The machine is programmed by default. Should the coffee
doses need to be modified, proceed as follows:
• Always programme the left pushbutton panel first. This way,
all the pushbutton panels will be automatically programmed.
If necessary, subsequently pro-
gramme the others.
• Press and hold down the
button for 5 seconds: the
button will flash and all the
pushbutton panel buttons be-
ing programmed will turn on.
• Fill the filter with a dose of
ground coffee and press it
down using the coffee press.
• Attach the filter holder to the
dispensing group.
• Place the coffee cup under
the dispensing spout.
• Press the desired dose button
(e.g. ).
• All of the LEDs will turn off, ex-
cept for the dose buttons being
programmed.
• Wait for the dispensing pro-
cess to finish; to confirm the
dose, press the dose button
again or the button.
P
rog
S
top
• Repeat this operation for the
other dose buttons.
• When you have finished pro-
gramming, press the
P
rog
S
ton to voluntarily exit the dose
programming mode.
User Manual
P
rog
S
top
P
rog
S
top
P
rog
S
top
P
rog
S
top
P
rog
S
top
but-
top
6.5.4

Displaying information

Depending on how the machine has been configured, when
the coffee is being dispensed, some information will appear
on the display.
Flow diagram
in time (ml/s) of
coffee dispensed for a
single group.
Viewing the
dispensing time
(secs) for all groups.
Viewing
the dispensing
temperature (°C) for
all groups.
P
rog
S
top
Plus4YouTS
Dispensing
pressure
Group 1
47 216
of